CH340 IC is a low cost USB to TTL converter IC. CH340g ICis used in low cost SMD Arduino UNO & Arduino Nano boards. Many USB to Serial converter IC’s are available in the market but this is a low cost IC that is gaining popularity. USB to TTL converter modules are also available based on this IC. Even Node MCU IOT modules also have this IC.

Calibration Security: On Dec 10, 2020, new engine control module (ECM) calibration codes will be released using industry standard encryption for all electronically controlled engine products. These ECM calibration codes are only supported in INSITE™ electronic service tool version 8.7.0 and newer. Native Drivers; ASI Cameras: This driver MUST be installed for Windows users to use ASI cameras.: v3.16. Change Log: Released. EFW: These products are USB HID devices so do not need native drive. Download intel mobile phones & portable devices driver.

Plug & Drive Studio 1 is a free software for easy commissioning and programming the Nanotec controllers, and tuning the motor. The software supports products with CAN (IXXAT & PEAK), serial, Ethernet.
Plug & Drive Studio 1 is a free software for easy commissioning and programming the Nanotec controllers, and tuning the motor. The software supports products with CAN (IXXAT & PEAK), serial, Ethernet.

You can download the Drivers for CH340g from below

Download CH340g Driver for windows 7, 8 and windows 10

Download For Windows 10 Free

I have personally tested the above CH340 driver on windows 7 and it worked with the Arduino Nano, Node MCU and Arduino UNO clones.

Nanotec Electronic Driver Download For Windows 10 64

Step By Step Installation of CH340g Drivers

Initially connect your hardware having CH340 USB to Serial IC to your PC. In the device manager it will show “USB2.0-Serial” (as shown in below figure) which means your ch340 driver has not been installed.

Now extract the CH340g drivers in a folder and in that you will find folder named “CH341SER” in which there will be a “setup” application file as shown below.

Nanotec electronic driver download for windows 10 3 8 5

Open the setup file and a “Driver Setup” option will open. Just click on the install file.

This installation takes some time. In my laptop it took 1 minute so just have patience. Once installed it will show driver successfully installed. Now go again back to device manager and there you will see that the driver has been successfully been installed and a com port has been allotted. In below image you can see that “com19” has been allotted for ch340g IC in my laptop

Drivers for the ch340 IC has now been installed successfully. I have tested this drivers and installation process in Windows XP, windows 7. Will test is soon on Windows 8 & windows 10.

You can see in above image that Port Number 19 has been allocated to this IC. If you want you can even change the virtual com port number from Device Manager.

Download Windows 10

For MAC users you can check CH340 Installation Guide for MAC users

Nanotec Electronic Driver Download For Windows 10

Please enable JavaScript to view the comments powered by Disqus.